Vaisala vLog 4.4 - Manual (Page 31)

Veriteq vLog 4.4 User’s Guide
25
To remove a user account:
1. In vLog, choose Tools>Administrator Options.
2. Click the Security tab.
3. To remove a user, highlight the name and click Remove.
4. Click OK to save, or Cancel to close without saving.
Setting up PC Communication Ports
Before using a data logger with Veriteq vLog, you must select the correct PC
serial communication (COM) port. Veriteq vLog can support up to 4096 COM
ports, numbered COM1 to COM4096.
To select a COM port:
1. Using Windows Device Manager, determine which COM port has been al-
located to your data logger. Make a note of it.
2. In vLog, choose Tools>Options, then choose the General tab.
3. From the COM port drop-down list, select an available COM port.
4. Click OK.
Once you have selected a COM port, you do not need to change the setting un-
less you change the communication port your loggers are connected to.
Configuring Data Loggers
Setting up the data logger varies slightly depending on the data logger you are
using and the configuration options you prefer. You can configure data loggers
one at a time (as follows), or do a Batch Setup of multiple loggers (see Config-
uring Data Loggers: Batch Setup on page 41).
Note: If you have high security enabled, you will need to confirm your pass-
word to finalize all logger configuration changes. For more on secu-
rity, see Setting Security Levels on page 22.