Assembling the fd12p – Vaisala FD12P User Manual
Page 40
User's Guide _______________________________________________________________________
40
______________________________________________________ M210296en-A
The following numbers and letters refer to Figure 7 on page 39:
A =
Mounting when casting the pad
1
=
A10.5 DIN125, 4 pieces
2
=
M10 x 30 DIN933, 4 pieces
3
=
A17 DIN125, 3 pieces
4
=
M16 DIN934, 3 pieces
5
=
Template
6
=
Foundation screw M16 x 250, 3 pieces
7
=
Base level
B
=
Mounting to an existing surface
6
=
Foundation screw M16 x 250, 3 pieces
8
=
Template
9
=
Wedge bolt M16, 3 pieces
C
=
Top view
10 =
M10, 4 pieces
11 =
Baseplate
Assembling the FD12P
1.
Mount the base plate and level it with the six M16 nuts.
2.
Mount the pole mast pedestal and the tilting support on the base
plate with four M10 bolts (Figure 7 on page 39, C, top view).
3.
Attach the electronics enclosure to the pole mast with two
clamps and four M6 Allen screws.
4.
Tilt the mast. See Figure 8 on page 41.
5.
Feed the crossarm cable and temperature sensor DTS14B cables
inside the pole mast.
6.
Check that a thin rubber gasket is on the insertion neck of the
crossarm.
7.
Connect the crossarm cable plug to the MIL-connector (see
Figure 10 on page 43).
8.
Connect the grounding flat connector to the other pin of the
ground terminal socket as shown in Figure 10 on page 43.