AT&T 1070 - Manual (Page 34)

48
Directory
Dial and remove an entry from the
directory
Dial a number from the directory
1. Find the entry for the number you wish to
call by following the directions under Review
directory entries on page 46.
2. Press [ENTER]. The screen displays DIAL.
3. Press [ENTER].
The phone will automatically select an idle line
and dial the call unless you choose a specific line
to dial the call by pressing the
[LINE] button, the
call will then be dialed in the mode (speakerphone
or headset) you programmed (see
AUTOMATIC
MODE on page 39 of the installation guide).
NOTE: While reviewing the numbers in the
directory, if you want to place a new call other than
the displayed number, you need to press
[DIR] or
wait for 30 seconds to return to idle.
Remove a name and number from the directory
1. Find the entry for the number you wish to
call by following the directions under Review
directory entries on page 46.
2. When the desired entry is displayed, press
[REMOVE]. The screen includes REMOVED!
The screen automatically advances to the next
directory entry.
NOTE: Once an entry is removed from the direc-
tory, it cannot be restored.
Pat Williams
5550100
DIAL
Pat Williams
5550100
REMOVED!