Agilent Technologies InfiniiVision 6000 Series - Manual (Page 22)

22
Performance characteristics
(continued)
General characteristics
Physical size 35.4 cm wide x 18.8 cm high x 28.2 cm deep (without handle)
39.9 cm wide x 18.8 cm high x 28.2 cm deep (with handle)
Weight Net: 4.9 kgs (10.8 lbs)
Shipping: 9.4 kgs (20.7 lbs)
Probe comp output Frequency ~2 kHz; Amplitude ~5 V
Trigger out When Triggers is selected (delay ~17 ns)
0 to 5 V into high impedance
0 to 2.5 V into 50
Ω
When Source Frequency or Source Frequency/8* is selected
0 to 580 mV into high impedance
0 to 290 mV into 50
Ω
Max frequency output: 350 MHz (in source frequency mode when terminated in 50 Ω)
125 MHz (in source frequency/8 mode when terminated in 50 Ω)
10 MHz ref in/out TTL out, 180 mV to 1 V amplitude with 0 to 2 V offset
Kensington lock Connection on rear panel for security
Power requirements
Line voltage range ~Line 120 W max, 96-144 V/48-440 Hz, 192-288 V/48-66 Hz, automatic selection
Line frequency 50/60 Hz, 100-240 VAC; 440 Hz, 100-132 VAC
Power usage 110 W max
Environmental characteristics
Ambient temperature Operating –10 °C to +55 °C; non-operating –51 °C to +71 °C
Humidity Operating 95% RH at 40 °C for 24 hr; non-operating 90% RH at 65 °C for 24 hr
Altitude Operating to 4,570 m (15,000 ft); non-operating to 15,244 m (50,000 ft)
Vibration Agilent class B1 and MIL-PRF-28800F; class 3 random
Shock Agilent class B1and MIL-PRF-28800F; class 3 random; (operating 30g, 1/2 sine, 11-ms
duration, 3 shocks/axis along major axis, total of 18 shocks)
Pollution degree2 Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation must be expected.
Indoor use Rated for indoor use only
Other
Measurement categories CAT I: Mains isolated
CAT II: Line voltage in appliance and to wall outlet
Regulatory information Safety IEC 61010-1:2001 / EN 61010-1:2001
Canada: CSA C22.2 No. 1010.1:1992
UL 61010B-1:2003
Supplementary information The product herewith complies with the requirements of the Low Voltage Directive
73/23/EEC and the EMC Directive 89/336/EEC, and carries the CE-marking accordingly.
The product was tested in a typical configuration with HP/Agilent test systems.
* Source Frequency/8 is supported on 300 MHz - 1 GHz 6000 Series only.