VariZoom VZCINEMAPRO-K5 - Manual (Page 4)

1. Basic Setup
Secure Cinema Pro head to crane, tripod, or solid mounting beam
Plug the FACTORY POWER SUPPLY into AC mains
Connect XLR cable between the Cinema Pro head and FACTORY POWER SUPPLY
Connect in Green LEMO connector between the Cinema Pro head and the plug marked “CTRL” on the
controller
Connect camera control (if applicable) between the camera and the 12-pin LEMO connector on the back
of the tilt arm on Cinema Pro head .
Connect camera power (if applicable) between the 2-pin LEMO connector also located on the back of
the tilt arm
Connect the bloop/sync (if applicable) between the camera and the 6-pin Fischer connector also located
on the back of the tilt arm
If using the TOC system
Connect the TOC 3A (3 axis lens drive box) between the orange 16-PIN lens control connector located on
the front of the tilt arm of the Cinema Pro head, and the grey “control” port located on the TOC 3A
Connect the Lens drive motors to the appropriate connection according to their function (zoom, focus,
iris)
If using a Preston MDR2*
Connect the MDR2 box between the 16-pin LEMO connector located on the front of the tilt arm of the
Cinema Pro head, and the appropriate command connected on the MDR2 box (refer to the
manufacturer’s instruction manual for proper connections)
Connect the Preston lens motors according to their manufacturer’s instruction manual