Videoswitch Vi200 - Manual (Page 34)

Digital Recorder
28
9.5 Network
Remote access software for the PC is available on the internet: www.videoswitch.co.uk
9.5.1 IP Address
If the Ethernet port of Vi200 is being used, a suitable IP address must be set. The IP
address must be unique and compatible with other devices on the network to which it
connects. If it is the only device connected to a router, the default IP address should be
suitable. Otherwise, refer to the network administrator. If you are connecting to a PC and
there is not a DHCP server, the PC will need to be programmed with a fixed IP address.
See section 11 for details of how to connect your Vi200 using the Ethernet connector.
9.5.2 Port
The default port setting (9221) should be suitable in most cases. Otherwise, refer to the
network administrator
9.5.3 Sub-Net mask
The default sub-net mask should be suitable in most cases. Otherwise, refer to the network
administrator
9.5.4 Gateway
The default gateway should be suitable in most cases. Otherwise, refer to the network
administrator
9.5.5 PSTN Rings
If a PSTN adaptor is being used, the number of rings before it answers may be set here.
9.5.6 Dial-up Type
Specify here whether an ISDN, PSTN or no remote dial-up adaptor is connected