Videoswitch Vi-POSCON - Manual (Page 5)

Videoswitch 5 Pos601a.doc
Vi-POSCON Installation Guide
1 CAUTIONS
CAUTION:
For continued protection against risk of fire, replace only with the same type and rating of
fuse.
PCB Legend Value Type
Fuse F1 1A @ 250V Ceramic "F"
Fuse F2 500mA @ 250V Ceramic "L"
Fuse F3 500mA @ 250V Ceramic "L"
CAUTION: Danger if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer. Dispose of
batteries according to the manufacturer's instructions.
IMPORTANT!
PLEASE READ CAREFULLY
PURCHASERS WHO INSTALL THIS DEVICE FOR USE BY OTHERS MUST NOT
LEAVE THIS DOCUMENT WITH THE CUSTOMER.
PRECAUTIONS: Check that the operating voltage as indicated on the type plate [label] of the Power
Supply Unit [PSU] is identical with the voltage of your local mains power supply.
LOCATION: For pluggable equipment [which is the PSU], the socket outlet shall be installed near the
equipment, [the PSU], and shall be easily accessible.
Do not expose the Vi-POSCON or the PSU to humidity, rain or excessive heat; they are for use in dry
areas only.
SAFETY: The Mains Plug is considered to be the means of disconnecting primary power. To isolate
the equipment fully, ensure that the Mains Plug is removed.
All Video, Data and Alarm switching signal connections must be to SELV* levels only, in accordance
with EN 6095 and UL 1950 3
rd
Edition.
INSTALLATION: Both the Vi-POSCON and the PSU are designed to be free standing on a horizontal
surface.
NOTES:
*SELV = Safety Extra Low Voltage.
PSU = Power Supply Unit.
A separate copy of this safety card is included with the Vi-POSCON Install Kit and must be left with
the user.
2 About this Guide
This document describes the installation and configuration of the Vi-POSCON System.
2.1 If you need assistance, call…
Videoswitch: 01252-851510