Videoswitch VT - Manual (Page 7)

VT Series 2 User Manual Page 7
Videoswitch
VT601c.doc
3. Switching
3.1 Manual Switching
Individual camera select keys are provided for all cameras (not applicable to VT-11). The VT-28A caters
for two monitors and provides a second row of camera select keys.
3.1.1 Manually Selecting a Camera (Monitor A)
Press one of the Monitor A camera select keys, identified 1,2,3,4,5,6,7 & 8 (lower row) to display the
required camera on Monitor A. Auto mode will be cancelled if previously set.
The selected camera is the one which the telemetry transmitter can now control.
3.1.2 Manually Selecting a Camera (Monitor B)
The VT-28A transmitter caters for a second monitor. Press one of the Monitor B camera select keys,
identified 1,2,3,4,5,6,7 & 8 (upper row) to display the required camera on Monitor B. Auto mode will be
cancelled if previously set.
3.2 Auto Switching
Auto switching may be used independently on either or both monitors. The dwell time for each monitor
may also be programmed, together with which cameras are required to be selected for each monitor
(section 8.1). Either sequential or random switching may be specified (section 8.2).
3.2.1 Auto Switching (Monitor A)
To set monitor A to auto, press the “AUTO A” key. The unit will step from one camera to the next with
the previously programmed dwell time.
Only the cameras that have been enabled (see section 8.1) will be selected in the sequence.
3.2.2 Auto Switching (Monitor B)
To set monitor B to auto, press the “AUTO B” key. The unit will step from one camera to the next with
the previously programmed dwell time.
Only the cameras that have been enabled (see section 8.5) will be selected in the sequence.