Zoo Med RM-10_ReptiSun - Manual

ZOO MED LABORATORIES, INC. 3650 Sacramento Dr. • San Luis Obispo, CA 93401 U.S.A. • Phone: 805-542-9988 • E-mail: [email protected]
www.zoomed.com
WARRANTY:
Zoo Med Laboratories, Inc. (Zoo Med) warrants this product to be free of defects in material and workmanship under normal use and service for one year from the date
of purchase. The obligation under this warranty is limited to the repair or replacement, at Zoo Med’s discretion, of the product or any part thereof, when the product is
returned to Zoo Med, freight prepaid. No claim shall be allowed under this warranty if, in the opinion of Zoo Med, this product has been subject to accident or improper
usage, including but not limited to: water damage, improper storage, accidental dropping, etc. This warranty is in lieu of all other warranties and representations
expressed or implied. Please include your receipt, full name, address, phone number, and email address along with a note explaining failure when sending any product
back to Zoo Med. Please allow 4 to 6 weeks for repair or replacement.
CHANGING OR REPLACING THE LED MODULES*:
*Reptisun LED filxture shown. Procedure is similar for Reptisun LED UVB fixture. If you have any questions, contact Zoo Med’s customer service department.
The LED modules in your light fixture can be replaced as needed at the end of the LED’s useful life.
IMPORTANT SAFETY NOTICE!
To reduce the risk of fire, injury, or electric shock, read and follow these instructions prior to operating this light fixture. Save these
instructions for future reference.
SAFETY INSTRUCTIONS:
• DO NOT exceed electrical rating. Only use the power supply
included with this fixture.
• DO NOT splice, repair, or modify. Fully extend cord before using.
• DO NOT use in wet conditions. Use indoors only. Not for use
with aquariums.
• Keep children and pets (other than your terrarium animals) away
from fixture.
5. Place the new LED module in the same location and orientation as the original module. The text on the LED module should be in the same orientation as the module
that was removed. Reinstall screws.
6. Reinstall the optics on the new LED module and reassemble by reversing the steps outlined above. If you have questions, please contact Zoo Med’s customer
service department.
4. Disconnect the wires from both ends of the LED module and remove the four screws and washers holding it in place. Remove the LED module from the housing.
1. Carefully remove one plastic
end cover by extending the
sliding rails and removing
the four screws using a
Phillips screwdriver. Gently
pull the end cover away,
being careful not to strain
the wires.
3. Carefully pull the optics
off of the LED module
that you are removing.
Save them for
reinstallation on the
new module.
Step 2
Step 3
2. Remove the clear splash guard
by sliding it out of the grooves.
Congratulations on your purchase of Zoo Med’s REPTISUN LED HO LED MODULE! The following instructions will assist you with the proper installation of this product.
Please read the following instructions carefully. If you have any questions regarding these instructions or the proper use of this item, please contact our customer
service department at [email protected] or by calling (888) 496-6633 (US and Canada only). Customers in other countries, please call (805) 542-9988.
• DO NOT use damaged cord sets – inspect periodically.
• DO NOT alter or modify this product. Contact an electrician if you are
unsure about the electrical connection.
• This unit uses LED modules that are designed to be replaceable. Do
not attempt to replace modules if you are unsure about the proper
procedure. Return to Zoo Med for inspection and repair.
LED MODULE
INSTRUCTIONS
FOR ITEM #’s LF-80, LF-81, LF-82, LF-83
LF-85, LF-86, LF-87, LF-88 and LF-89
REPTISUN
HO LED LED
Step 1
Step 4a
Step 4b Step 5