Zoo Med LF-85_ReptiSun_LED_UVB - Manual

• BRILLIANT LIGHT! 6500K daylight high output LEDs for truly naturalistic lighting.
• UVB: ReptiSun 5.0 T5 HO (high-output) lamp included for safe & effective UVB, UVA
and bright light for improved color rendering.
• PLANT GROWTH: 620 nm RED LEDs stimulate live plant growth.
• MOON LITE®: 465 nm BLUE LED simulates nighttime lighting “Lunar Effect”.
• MODULAR DESIGN: Individual LED modules & quick disconnects allow for easy
replacement of LED modules. Never throw another LED fixture away again!
• DUAL SWITCHES FOR INDEPENDENT CONTROL OF THREE
LIGHTING MODES.
• HANG OR SET ON TERRARIUM: Adjustable legs and stainless steel suspension kit included.
• LONG LIFE: 20,000 hour life range!
SAFETY INSTRUCTIONS:
To reduce the risk of fire, injury, or electric shock, read and follow these instructions prior to operating this light fixture. Save these instructions for future reference.
Congratulations on your purchase of Zoo Med’s REPTISUN LED UVB TERRARIUM HOOD! The following instructions will assist you with the proper set-up and operation of this unit.
Please read the following instructions carefully. If you have any questions regarding these instructions or the proper use of this item, please contact our customer service department at
[email protected] or by calling (888) 496-6633 (US and Canada only). Customers in other countries, please call (805) 542-9988.
FEATURES:
ITEMS COVERED:
LF-85, LF-86, LF-87,LF-88 and LF-89
INSTRUCTIONS
Fixture with Suspension Kit
• SUSPENDED OVER TERRARIUM USING SUSPENSION CABLES:
CAUTION: See suspension kit warning section for important safety information before hanging this light
fixture over your terrarium. To hang your fixture above your terrarium using the enclosed stainless steel
aircraft cable suspension kit, perform the following steps:
• If installed, remove the four plastic sliding rails from the aluminum frame.
• Insert two T-nuts into each slot on the top of the fixture, then insert the four plastic plugs into the slots on
the plastic end covers to prevent the nuts from sliding out of the frame.
• Check to make sure that the cable lock nut on the center fitting is loose to allow the shorter cable to slide
freely. This will be tightened later.
• Fully thread the cable fittings onto the T-nuts as shown. Each cable has two threaded fittings which must
be installed on one end of the fixture. DO NOT thread both fittings from one cable onto T-nuts in the same slot.
• With the lamp fixture resting on a flat surface, gently pull up on each center cable and tighten the cable lock nuts on the center fittings.
• Secure the long center cables using appropriate hardware to suspend the fixture (see suspension kit warning above).
LED OPERATING INSTRUCTIONS:
This lamp fixture has three different lighting modes that are controlled by three switches:
WHITE LEDs ONLY: 6500K white daylight LEDs provide bright naturalistic light in your terrarium. Use this mode for terrariums
without live plants, including desert habitats and terrariums with artificial plants.
WHITE & RED LEDs: 6500K white daylight LEDs with 620nm red LEDs provide bright naturalistic light in addition to red
wavelengths that stimulate plant growth. Use this mode for all terrariums with live plants.
BLUE MOONLITE® LED: Low light 465nm blue LED simulates “Lunar Effect” and provides for nighttime viewing without
disturbing your animals’ sleeping patterns (photoperiod). Be sure to turn off white and red LEDs at night to provide your animals
with a proper photoperiod.
REPTISUN T5HO UVB LAMP OPERATING INSTRUCTIONS:
The REPTISUN T5HO UVB lamp is controlled by a separate switch and power cord from the LEDs. This lamp fixture includes one REPTISUN 5.0 T5HO
lamp. Please see the application chart below to determine the correct distance from the lamp to your reptile’s basking site. NOTE: For taller/larger
habitats, the REPTISUN 10.0 T5HO lamp is optional and may be used instead for deeper UVB penetration.
APPLICATION CHART:
LAMP USED RECOMMENDED OPERATING RANGE
REPTISUN 5.0 T5HO UVB (included) 12" to 18" (30 - 45 cm)
REPTISUN 10.0 T5HO UVB (optional) 18" to 30" (30-76 cm)
REPTISUNLEDUVB LEDUVB
LED
UVB
+
LED HO
REPTISUN 5.0
HIGH OUTPUT MODULES
T5HO UVB LAMP
IMPORTANT:
This appliance has a GROUNDED plug for safety and must be plugged into a grounded receptacle. Do not modify the plug in any way.
SUSPENSION KIT WARNING:
Failure to securely suspend this fixture over a terrarium can result in damage, injury, or electric shock. When suspending this light fixture using the enclosed suspension kit, be sure that
the cables are securely attached to hardware that is capable of supporting the weight of the light fixture. If you are unsure about safe hanging methods, contact a qualified licensed
contractor to hang this fixture for you. Zoo Med Laboratories, Inc. accepts no liability for damage or injury resulting from improper or unsafe use of the suspension kit.
INSTALLATION INSTRUCTIONS:
Zoo Med’s ReptiSun LED UVB Terrarium Hood can be installed over your terrarium using one of the following methods:
• DIRECTLY ON TERRARIUM USING SLIDING RAILS:
This fixture can be placed directly on top of your terrarium. To install using the adjustable sliding rails,
adjust the width of the rails to match the width of the terrarium, and securely place the fixture on the
upper terrarium frame. Each rail should be extended the same amount, and should not be pulled
completely from the aluminum housing. Be sure to leave at least 1” of each plastic rail in the aluminum
housing for adequate support.
• CAUTION: REPTISUN T5HO UVB lamp emits ultraviolet radiation. This light fixture is
intended for reptile use only. Carefully follow instructions to achieve a safe distance
from the lamp to your reptile(s). Always place lamp directly overhead of your animals.
DO NOT place the lamp to the side, forcing animals to stare into the lamp.
• REPTISUN T5HO UVB lamp contains mercury. Manage in accordance with
disposal laws.
• DO NOT exceed electrical rating. Only use the power supply included with this fixture.
• DO NOT splice, repair, or modify. Fully extend cords before using.
• DO NOT use in wet conditions. Use indoors only. Not for use with aquariums.
• Keep children and pets (other than your terrarium animals) away from fixture.
• Fully insert plugs. Unplug power cords before performing fixture maintenance (including
replacing lamp or changing LED modules).
• DO NOT cover with blankets, rugs or any material.
• DO NOT use damaged cord sets – inspect periodically.
• DO NOT alter or modify this product. Contact an electrician if you are unsure about the
electrical connection.
• This unit uses LED modules that are designed to be replaceable. Do not attempt to replace
modules if you are unsure about the proper procedure. Return to Zoo Med for inspection
and repair.
(CONTINUED)