Avaya S8300 - Manual (Page 128)

128 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Configure the G700 Media
Gateway (See
Using the Avaya
Installation Wizard (IW) on
page 161
-Assign IP addresses to the G700 processors
-Set up default IP route for the G700
-Check IP connections
-Set up controller list for the G700
- Configure X330 Expansion Module, if
necessary
Install new firmware on the
G700 and media modules (See
Using the Avaya Installation
Wizard (IW)
on page 161
-Verify contents of the tftp directory
-Determine which firmware to install
-Install firmware on the P330 Stack Processor
-Install firmware on the G700 media gateway
processor
-Install firmware on the media modules
-Install firmware on other G700s in the stack
or network, if any
-Set Rapid Spanning Tree
Installing IA770 service pack
files, if any on page 170
- Log in to the S8300 platform
- Install IA770 service pack, if any
- Stop the system
- Restart the system
- Enable messaging on the S8300 Web
interface, if necessary
Administer Communication
Manager
on page 173
- Reboot the system
- Assign node names, if necessary
- Administer network regions
- Assign LSPs to network regions
- Administer IP interfaces
- Administer the LSP form
- Add media gateway
- Verify changes
- Enable announcements, if necessary
- Save translations
Considerations for IP Phones
Supported by a Local Survivable
Processor
on page 193
Complete the Installation of the
S8300 (if the Primary
Controller)
on page 195
- Register the system
- Back up the system
- Check planning documentation
- Connect and administer test endpoints
- Complete electrical installation
- Enable adjunct systems
Checklist 1: Install New G700 with an S8300 (Primary or LSP) with the Avaya
Installation Wizard (continued)
Major Tasks Subtasks
2 of 3