Avaya S8300 - Manual (Page 501)

Configure the G700 Media Gateway
Issue 9.1 June 2006 501
10. At the MG-???-1(super)# prompt, type configure to reach the configuration level of the
command line interface.
11. Type show interface mgp to verify that the G700 media gateway has the correct IP
address.
To assign the default IP route to the G700 media gateway
1. At the MG-???-n(configure)# prompt, type
set ip route 0.0.0.0 0.0.0.0 <default_gateway>
to specify the gateway to handle addresses outside of the local subnet.
<default_gateway> is the IP address of the default network gateway. This address
should be available in the planning documentation.
2. Type show ip route mgp to view the results.
3. Repeat Step 1 for additional ip routes, if needed.
Usually, only a default route is needed. Refer to your planning document.
From the G700 media gateway processor command line interface, you assign IP addresses to
the VoIP resource resident on the G700 media gateway and to any installed MM760 VoIP media
modules.
To assign IP addresses to the VoIP resources
1. At the MG-???-n(configure)# prompt, type set interface voip <number> <ip
address>
<number> is the slot number of the VoIP media module. v0 designates the VoIP resource
resident on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are
designated according the slot (for example, v1, v2, v3, v4) in which the media module has
been installed.
<ip address> is the IP address of the VoIP resource.
For example: set interface voip v0 132.236.73.3
2. Type show interface to display a table of all configured interfaces, including all VoIP
Media Modules.
3. Type show voip v0 to display the VoIP resource on the motherboard.
Note:
Note:
It is not necessary to configure the VLAN, netmask, or IP routes for VoIP engines.
The media gateway parameters are applied automatically.