Audiovox PAV6D - Manual (Page 8)

5
When wiring is completed, you should follow the procedures provided below before
operating the DVD Changer.
The DVD Changer is designed to play DVD video/video CD/audio CD. The video signals
may be directly connected to the video input and the audio signals can be connected to the
AUX input of FM modulator head unit, respectively using a DIN cable.
When connecting the DVD CHANGER with a FM MODULATOR
Setting for operation
1. Insert the disc into the magazine and then install the magazine into the DVD Changer.
Then the DVD Changer checks the disc in the magazine.
2. Turn on the power for the car stereo and then connect the audio signals.
3. Set the radio at 88.7MHz. (Frequency is determined depending on the type of FM
modulator.)
4. Turn on the monitor and then switch to video mode.
Note : Please refer to the manuals for car stereo and monitor.
Power on and play
1. Turn on the power for the monitor by pressing the power button of the remote control.
The initial screen will display DISC CHECK enabled.
After disc checks the number 1 disc will be played.
2. Use the car stereo and control buttons to adjust the audio (volume, balance, tone, etc.)
according to your preference. Adjust the video (shade, contrast, tone, etc.,) using the
monitor controls.
Note.
When the magazine is inserted, the device will check the discs in each tray to set the disc
list. When DISC BEING CHECKED is displayed, the disc list is being set. If you want to
play the disc without waiting for disc list setting, please press DISC UP/DN( , ) and the
ENTER button.
When using a DVD, the title menu screen and DVD menu screen will be displayed
depending on the type of discs. When using a video CD, the PBC menu screen will be
displayed depending on the type of discs.
The playback information will differ depending on the disc types (DVD/video CD/audio
CD/MP3).
Refer to the manuals for the car stereo and monitor.
Pre-Operational Check