AT&T 882 - Manual (Page 44)

Call Identification
40
AT&T 882 Manual
Incoming Call Messages
Message Meaning
OUT OF AREA This message may appear for some long distance calls or calls
originating from an area not covered by Call Identification Service.
This message may also appear if the caller’s local telephone company
uses equipment incompatible with that of your local telephone
company.
PRIVATE The phone number or name not available at the
caller’s request.
CALL ID
ERROR Incoming Call Identification was not complete.
Rep =3 When someone calls several times from the same phone number, the
phone only keeps a record of the most recent call. The phone displays
how many times the call was repeated (up to nine times).
Call 5 Position of the call in the Incoming Call Log.
Incoming Call Log (InLog)
The Incoming Call Log stores information for up to 64 phone
calls. You must subscribe to this service for both lines to receive
Incoming Call information about both lines. The most recent call
is call #1. For example, if there are 5 calls in memory, call #1 is
the most recent call and call #5 is the oldest. If the memory is
full, the oldest call is deleted to make room for the new incoming
call.
Reviewing InLog
When you begin to review the Incoming Call Log, the most recent
calls appear on the display.
The and buttons are used to move back or forward, one
display at a time, to scan the call log.
Reviewing InLog 1 Press the soft key below InLog.
2 Use to review InLog.
3 Press the soft key below Exit when you are done.
5