AEG FAVORIT 88070 VIL, - Manual (Page 17)

Operating instructions
17
Adjusting the dose
According to the finish and drying results obtained, adjust the dose of
rinse aid by means of the 6 position selector (position 1 minimum
dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of
water or lime spots on the dishes after
washing.
Reduce it if there are sticky whitish
streaks on the dishes or a bluish film on
glassware or knife blades.
Top up the rinse aid when REFILL RINSE AID appears in the display.
This occurs only during the setting mode and at the end of the
washing programme: during the progress of the washing programme
the indication for rinse aid refilling is not active.
If you are using dishwasher detergent that already contains rinse aid,
the detergent including the rinse aid must be placed in the detergent
compartment. In this case the rinse aid inflow must be deactivated in
order to avoid a double dosage.
Deactivation/activation of the inflow of rinse aid
Factory setting: RINSE AID YES
to deactivate the dosage:
1. Press OPTION button
2. Press DIRECTION buttons until SETTINGS... is displayed
3. Press OK START button
4. Press DIRECTION buttons until RINSE AID is displayed
3. Press OK START button
4. Press DIRECTION buttons until NO is displayed.
5. Press OK START button to confirm the setting
6. Press OPTION button to exit the Options menu.
BR09
152963991en per CH.qxp 03/08/2004 13.39 Pagina 17