AEG FAVORIT 88070 VIL, - Manual (Page 27)

Operating instructions
27
Starting a washing programme
In this fully integrated appliance the controls are located on the top of
the door. When selecting a programme, the door needs to be open.
1. Check that the baskets have been loaded
correctly and that the spray arms can rotate
freely
2. Turn on the water tap
3. Press the On/Off push button
4. Setting and starting the programme
Press DIRECTION buttons until the name of the desired programme
is displayed (see “Washing programmes” chart).
Select, if desired, options (see “How to set options”).
Press OK START button.
Close the door.
a) if the delay start has not been set, the programme will start
automatically.
Once the washing programme has started, a point-shaped optical
signal appears on the floor beneath the dishwasher’s door.
This optical signal will remain illuminated for all the duration of the
washing programme. If the appliance has been installed higher up with
a furniture door mounted flush, the optical signal will be no longer
visible.
"AUTOMATIC" washing programme
During the "AUTOMATIC" washing programme the amount of soil on the dishes is determined by how
cloudy the water is.
If the appliance is partially loaded and the dishes lightly soiled, the "prewash"", main wash", and "rinse"
phases of the programme are shorter and the water consumption level is lower.
If the appliance is fully loaded and the dishes heavily soiled, the "prewash"", main wash", and "rinse" phases
of the programme are longer and the water consumption level is higher.
For this reason the programme duration, water and energy consumption levels can vary within the stated
range for AUTOMATIC programme (see "Washing programmes chart").
During the "AUTOMATIC" programme the temperature of the main wash water is also automatically
adjusted between 50°C and 65°C depending on the amount of soil on the dishes.
152963991en per CH.qxp 03/08/2004 13.39 Pagina 27