AEG FAVORIT 88070 VIL, - Manual (Page 33)

Operating instructions
33
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...alarm messages or codes are displayed
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- a continous sequence of intermittent audible signals
- the point-shaped optical signal on the floor beneath the
dishwasher’s door is flashing.
Open the dishwasher’s door, a message or a code (as indicated in the
following chart) is displayed.in digital display is visible a fault code
(see following chart).
Carry out the following suggested corrective actions.
Fault code / message
in the digital display
appears
“OPEN THE TAP”
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the siphon. The siphon is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed. Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Possible cause Solutions
in the digital display
appears
“DRAIN BLOCKED”
The dishwasher will not
drain
Close the water tap and
contact your local Service
Force Centre. Protection against flooding is
active. in the digital display
appears
152963991en per CH.qxp 03/08/2004 13.39 Pagina 33