AEG FAVORIT 88070 VIL, - Manual (Page 38)

Installation instructions
38
Installation instructions
Any electrical and/or plumbing work required to install this
appliance should be carried out by a qualified electrician and/or
plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Building-in
This dishwasher is designed to be fitted under a kitchen counter or
worksurface.
Attention!
Carefully follow the instructions on the enclosed template for
building in the dishwasher and fitting the furniture panel.
No further openings for the venting of the dishwasher are required,
but only to let the water fill and drain hose and power supply cable
pass through.
The dishwasher incorporates adjustable feet to allow the adjustment
of the height.
During all operations that involve accessibility to internal components
the dishwasher has to be unplugged.
When inserting the machine, ensure that the water inlet hose, the
drain hose and the supply cable are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable
feet until the machine is perfectly level.
Fixing to the adjacent units
The dishwasher must be secured against tilting.
Therefore make sure that the counter it is fixed under, is suitably
secured to a fixed structure (adjacent kitchen units cabinets, wall).
152963991en per CH.qxp 03/08/2004 13.39 Pagina 38