Kenwood KDC-DAB41U - Manual (Page 32)

32
English
STEERING WHEEL
REMOTE INPUT
MUTE
ANT. CONT
P.CONT
REMOTE CONT
L
R
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Antenna Cord
FM/AM antenna
input (JASO)
DAB antenna input
(SMB) (“DAB ANT
POWER” page 7)
USB connector
AUX input (Stereo)
Use the mini-plug (3.5 mm ø) cable which
is stereo type and does not have any
resistance.
Pin Color and function Pin Color and function
A4 Yellow Battery B1 / B2 Purple ª / Purple/black · Rear speaker (right)
A5 Blue/White Power control B3 / B4 Gray ª / Gray/black · Front speaker (right)
A7 Red Ignition (ACC) B5 / B6 White ª / White/black · Front speaker (left)
A8 Black Earth (ground) connection B7 / B8 Green ª / Green/black · Rear speaker (left)
Rear output/ Sub
Woofer output
switchable (“SWITCH
PREOUT” page 7)
Connector A
Connector B
Vehicle Unit
Default wiring
To use the steering wheel remote control feature,
you need to an exclusive remote adapter (not
supplied) matches your car is required.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
If no connections are made, do not let the wire come out from the
tab.
Wiring
harness D
Fuse (10A)
Connecting the ISO connectors on some VW/Audi
or Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied
wiring harness as illustrated below.
Light Blue/Yellow
(Steering remote
control wire)
Brown
(Mute control wire)
Blue/White
(Power control/
Antenna control wire)
Red (A–7 Pin)
Yellow (A–4 Pin)
Yellow (Battery wire)
Yellow (Battery wire) Yellow (A–4 Pin)
Red (Ignition wire)
Red (Ignition wire) Red (A–7 Pin)
Wiring connection
To Kenwood disc changer/ External
optional accessory
(To connect these leads, refer to the
relevant instruction manuals.)
B64-4833-00_01_E.indb 32 B64-4833-00_01_E.indb 32 11/03/07 11:09 11/03/07 11:09