Kenwood KDC-DAB41U - Manual (Page 35)

English
35
Continued to next page
150 mm
70 mm * 1
Antenna film F
Earth sheet
Earth sheet
Amplifier G
Amplifier G
Front pillar
When installing the antenna on the left side When installing the antenna on the right
side
Antenna film F
150 mm
70 mm * 1
Determining the antenna installation location
Antenna Installation
1 Check the installation location.
2 Wipe the area where antenna film F,
amplifier unit G, and earth sheet are
pasted with the included cleaner I.
The coating on the metal surface need not
be removed.
■ Wait until the glass surface is completely
dry before pasting.
■ If the glass surface is cold, such as during
winter, warm it with defroster or dryer.
3 Remove the separator (tag I) of antenna
film
F horizontally and paste the
antenna on the front glass.
■ Remove the separator gently.
■ Do not touch the pasting surface
(adhesive side) of the antenna film F.
4 Remove the separator (tag II) of antenna
film
F vertically and paste the antenna
gently while applying pressure.
5 After pasting, rub the element in the
glass surface in the direction of the arrow
shown in the figure to bond it.
6 Remove the application film (tag III).
■ Do not touch the feeder terminal of the
element. Also, do not apply any glass
cleaner.
Feeder terminal
• * 1 Where the earth sheet of Amplifier G can be pasted on the metal part of the front pillar.
B64-4833-00_01_E.indb 35 B64-4833-00_01_E.indb 35 11/03/07 11:09 11/03/07 11:09