Kenwood KDC-DAB41U - Manual (Page 34)

34
English
Installation the DAB antenna (KDC-DAB41U only)
CAUTION
■ This film antenna is exclusively for use inside
the vehicle.
■ Do not install at the following locations:
– Where it may block driver’s view
– Where it may obstruct operation of safety
devices such as air bags
– On movable glass surface such as rear
hatch
■ Signal strength will decrease at the
following locations:
– On IR reflecting glass or where covered
with mirror type glass film
– Where it overlaps with genuine radio
antenna (pattern)
– Where it overlaps with window heating
wires
– At side of vehicle (e.g. door, front quarter
window)
– On rear window
– When glass that blocks radio signals (e.g.
IR reflecting glass, thermal insulation glass)
is used
– Reception may decrease due to noise
when windshield wiper, air conditioner, or
motor is turned on.
– Reception may decrease depending on
the direction of the broadcast station with
respect to the vehicle (antenna).
■ Be sure to check the installation location
of film antenna F before installing. Film
antenna cannot be re-pasted.
■ Thoroughly wipe oil and dirt from the
pasting surface with the included cleaner
I.
■ Do not bend or damage the film antenna F.
■ Warm the pasting surface by turning on the
heater for example, before applying.
■ It may not be possible to install on some
type of vehicle.
■ Check the cable routing of the film antenna
F and amplifier G before pasting.
Installation overview
DAB antenna F/ G
Antenna cable
(3.5 m)
■ The antenna should be installed on the
passenger side for safety.
■ Use cord clamper H to secure the antenna
to the pillar at several locations.
■ The direction of the antenna film F
changes depending on whether the film
antenna F is installed on the right side or
left side.
■ Separate the antenna film F from the
ceramic line (black part) at the top of the
front glass by 150 mm.
Also, place it about 70 mm inside the
ceramic line at the side end of the front
glass. (where the earth sheet of the amplifier
can be pasted on the metal part of the front
pillar)
■ Separate from other antennas by at least
100 mm.
■ Do not paste the amplifier G on the
ceramic line (black part) around the
front glass. Because there is not enough
adhesion.
B64-4833-00_01_E.indb 34 B64-4833-00_01_E.indb 34 11/03/07 11:09 11/03/07 11:09