Kenwood BDR-A7 User Manual

Page 22

Advertising
background image

22

English

When selecting the CROSSOVER FREQUENCY

1.

Press the CURSOR UP/DOWN buttons to select the “X OVER”, then press the OK button.

• Then “X OVER ~” will be displayed.

2.

Press the CURSOR LEFT/RIGHT buttons to set the crossover frequency as desired.

• You can select the crossover frequency among 50, 80, 100, 150 and 200 Hz.

About the crossover frequency

• When speakers are set to “SMALL”, low frequencies in those channels that are below the crossover frequency are to

output from subwoofer or front speakers which are set to “LARGE” (when not using a subwoofer).

• Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100Hz ~

20kHz, the crossover frequency should be set to 100 Hz (or slightly higher).

When selecting the CHANNEL LEVEL

1.

Press the CURSOR UP/DOWN buttons to select the “CH LEVEL”, then press the OK button.

• Then “T TONE ~” will be displayed.

2.

Press the CURSOR LEFT/RIGHT buttons to select the desired mode.

• Each time these buttons are pressed, the mode changes as follows :

M (MANUAL) : To move the test tone manually from speaker to speaker and to adjust the individual channel levels.

A (AUTO) : To adjust the channel levels as the test tone moves from speaker to speaker automatically.

3.

Press the OK button to confirm your selection.

• After the volume increases to the reference level, test tone will be output.
• When the “A” (AUTO) is selected, the test tone will be output from each speaker for 2 seconds.

4.

Press the CURSOR LEFT/RIGHT buttons to adjust the level of each channel.

• When the “M” (MANUAL) is selected, select the speakers to be output the test tone with using the CURSOR UP/DOWN

buttons.

• You can adjust the channel level within the range of -15 ~ +15 dB.

Note :

• The test tone will not be output from the speakers set to “NO”.

5.

To cancel the test tone function, press the RETURN button.

• The previous menu will be returned.

BDR-A7_EN_CS3.indb 22

BDR-A7_EN_CS3.indb 22

11.3.10 6:59:36 PM

11.3.10 6:59:36 PM

Advertising