Kenwood BDR-A7 User Manual
Page 45
45
English
1.
Perform the steps 1 and 2 in “OSD Menu Settings”
procedure on page 40 to select the Network.
• Then the network setting menu will be displayed.
Wired :
Configures network settings depending on your internet
environment, etc. when connecting to the internet.
Network Test :
Detects the internet connection and automatically
configures the network settings by the DHCP server
function of the router or modem.
■ Note :
• When IP Mode is set to Off, Network Test cannot be
selected.
2.
Press the CURSOR UP/DOWN buttons to select
the network configuration mode, then press the OK
button.
• When selecting the Network Test, see page 46.
When selecting the Wired
Then the IP Settings menu will be displayed as follows :
3.
Press the CURSOR RIGHT button to display the IP
Mode.
Off:
Disables this unit’s LAN capabilities.
Manual :
Configures network settings manually.
Dynamic (default setting) :
Automatically configures the network settings by the
DHCP server function of the router or modem.
■ Note :
• Select the Manual only when the DHCP server function
of the router or modem cannot be used for the automatic
configuration.
4.
Press the CURSOR UP/DOWN buttons to select
the desired IP Mode, then press the OK button.
■ When selecting the Manual
• You can select IP Address, Subnet Mask, Gateway,
Primary DNS and Secondary DNS to configure them
manually.
• On the IP Settings menu, “Link Status” and “Mac
Address” display the corresponding information merely.
1 Press the CURSOR UP/DOWN buttons to select the
desired option, then press the OK button.
Then the New Value entry screen will be displayed.
Example : When selecting IP Address
2 Enter the new value pressing the NUMERIC buttons,
then press the CURSOR buttons to select “OK” and
press the OK button.
3 Repeat the above steps 1 and 2 until other new
values are all entered.
• To access BD-LIVE contents from websites, you should connect this unit to the internet and set the communication
settings. (For details, “CONNECTING TO NETWORK” on page 9.)
• When you set the communication setting manually, the following information of the connected router or modem is
required. Confirm the information prior to the setting : IP address, Subnet mask, Gateway, Primary DNS and Secondary
DNS.
MAC Address
Link Status
IP Settings
IP Mode
Apply
Cancel
Link Up
Dynamic
00:23:03:00:50:b4
IP Address
192.168.1.110
Subnet Mask
255.255.255.0
Gateway
192.168.1.1
Primary DNS
168.126.63.1
Secondary DNS 0. 0. 0. 0
Please enter a new IP Address.
Valid range of each segment is 0 to 255.
Current value 192.168.1.110
New Value
.
.
.
OK
Cancel
SETTING THE NETWORK
Continued
BDR-A7_EN_CS3.indb 45
BDR-A7_EN_CS3.indb 45
11.3.10 6:59:42 PM
11.3.10 6:59:42 PM