Kenwood BDR-A7 User Manual
Page 23
23
English
• You can adjust the tone (bass and treble) as desired.
• Settings with* are the default.
• Press the CURSOR LEFT/RIGHT buttons to set the tone mode as desired.
OFF : To listen to a program source without the tone effect.
↕
ON : To adjust the tone for your taste.
■ When the TONE CONTROL is set to ON to adjust the tone (bass and treble)
1
. Press the OK button to enter the tone adjustment mode.
• Then “TRE ~” will be displayed.
2
. Press the CURSOR UP/DOWN buttons to select the desired tone mode.
3
. Press the CURSOR LEFT/RIGHT buttons to adjust the selected tone as desired.
• The tone level can be adjusted within the range of -10 ~ +10 dB.
• In general, we recommend the bass and treble to be adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your speakers.
• To complete tone adjustment, repeat the above steps 2 and 3.
■ When selecting the SPEAKER DISTANCE
1.
Press the CURSOR UP/DOWN buttons to select the “DISTANCE”, then press the OK button.
• Then “L ~” will be displayed.
2.
Press the CURSOR UP/DOWN buttons to select the desired speaker.
■ Note :
• You cannot select the speakers set to “NO”.
3.
Press the CURSOR LEFT/RIGHT buttons to set the selected speakers as desired.
• You cannot set the distance within the range of 0.1 ~ 9.0 meters in 0.1 meter intervals.
4.
Repeat the above steps 2 and 3 until the distances are all set as desired.
■ About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center,
surround, surround back and subwoofer speakers should be the same distance from the main listening position as the
front speakers. By entering the distance between the listening position and each speaker, the delay times of center,
surround, surround back and subwoofer speakers are automatically adjusted to create an ideal listening environment
virtually as if the center, surround, surround back and subwoofer speakers were at their ideal locations respectively.
Setting the Tone
TONE ON* / OFF
TRE 0* / -10 ~ +10
BASS 0* / -10 ~ +10
BDR-A7_EN_CS3.indb 23
BDR-A7_EN_CS3.indb 23
11.3.10 6:59:36 PM
11.3.10 6:59:36 PM