Kenwood CAW1300-06 - Manual (Page 4)

2-DIN 12.CAW1300-06
Remove the surrounding
around the original radio
at the location of the ar-
rows.
1 2 3
4 5 6
Remove the original OEM metal
brackets from the radio.This is
tighten by eight screws. Place the OEM radio brackets on the me-
tal bracket for the new headunit.
This will fi t in the holes of the metal
bracket(if needed mount it with screws).
Place the metal bracket into the dash-
board between the metal OEM
brackets.
7
8
9
Place the new headunit Place the OEM replacement panel.
Place the radio trim and place all dash-
board panels in reverse order.
10
Remove the top air shaft by pulling
it forwards. Remove the original radio at the
location of the arrows this is tighten
by four screws.
7R\RWD$XULV
Remove the dashboardpanels around
the radio at the location of the ar-
rows.