Kenwood CAW1300-06 - Manual (Page 8)

2-DIN 12.CAW1300-06
Remove the orginal radio this is
tigten by four screws.
Place the OEM radio brackets on the
metal bracket of the new headunit.
This will fi t in the holes of the metal
bracket(if needed mount it with screws). Place the metal bracket in to the
dashboard. Place the OEM replacement panel.
Place the new headunit and replace
the dashboard panels in reverse
order.
Remove the dashboardpanels around
the radio at the location of the
arrows. Remove the top air shaft by pulling it
forwards.
7R\RWD&RUROOD!
Remove the OEM brackets from the
original radio.This is tighten by eight
screws.
Place the radio trim and replace al
dashboardpanels in reverse order.
1 2 3
4 5 6
7
8
9
10
11
Place the metal bracket into the
dashboard between the metal OEM
brackets.