Kenwood CAW1300-06 - Manual (Page 6)

2-DIN 12.CAW1300-06
Remove the air shafts at the left and
the right side of the OEM radio by
using a plastic wedge.
1 2 3
4 5 6
Remove the original OEM metal
brackets from the radio.
This is tighten by four screws Place the OEM metal brackets on the
metal bracket of the new headunit.
This will fi t into the holes of the metal
bracket(if needed mount it with screws).
7 8 9
Remove the warning lights switch
unit from the original panel and place
it in the replacement panel. Place the new headunit.
Place the new OEM replacement
panel.
10 11
Place the radio trim and replace all
dashboardpanels in reverse order.
Remove the climate control unit.
This is tighten by two screws and pull
the unit forwards. Remove the original radio by
removing the four screws at the
location of the arrows.
7R\RWD&RUROOD9HUVR
Place the metal bracket into the
dashboard between the metal OEM
brackets.