MagTek Excella STX99875340 - Manual (Page 65)

Section 5. Keys Sent to Device
55
MICRFmtCode
This key specifies the pre-defined output format to be use for MICR data. This key is supported by
Excella and Excella STX.
Values Value Description
numeric string Specifies the format code number (refer to Appendix A)
Sequence
The Sequence key is used to control the movement of the check document in the path. All available
sequences or check moves are described below. Each check move is identified by the value of the
Sequence key. If the Sequence key is not specified or an invalid value is use, the normal check process is
used. This key is supported by Excella and Excella STX.
Values Value Description
SEQ_0 The check move starts at the entry point. The check moves forward and it is
pinched at the exit point. At the beginning of this sequence, the LED flashes
green to indicate that a check must be inserted. When the check is inserted,
the LED is turned off. If requested, the following operations can occur during
this sequence: scanning front image, reading MICR line, endorsing, franking,
and scanning back image. The data available after this sequence can include
the MICR line, front image, and back image. Information on the images
includes the image size and the URL string which the host can use to request
the images.
SEQ_1 The check move starts at the entry point. The check moves forward and it
stops at a point near the back printer. At the beginning of this sequence, the
LED flashes green to indicate that a check must be inserted. When the check
is inserted, the LED is turned off. If requested, the following operations can
occur during this sequence: scanning front image and reading MICR line. The
data available after this sequence can include the MICR line and the front
image. Information of the front image includes the image size and the URL
string which the host can use to request the image.
Invalid conditions:

This sequence move is valid only if the path is clear at the beginning of the
move. A jam will be reported if a check is detected in the path. The check
must be cleared off the path before the sequence can begin.

This sequence move is valid only if there is no request for endorsing or
franking. If there is a print request, error 306 ("Selected Print is Invalid For
Selected Sequence") is returned.

This sequence move is also valid only if the requested image is the front
side. If there is a request for the back side image, error 405 ("Scan Side is
Invalid For Selected Sequence Move") is returned.