MagTek Excella STX99875340 - Manual (Page 67)

Section 5. Keys Sent to Device
57
Values Value Description
SEQ_5 The check move starts at the exit point. The check moves in reverse to a point
near the back printer, it then moves forward again, and it is pinched at the exit
point. If requested, the following operations can occur during this sequence:
endorsing, franking, and scanning back image. The data available after this
sequence includes the back image. Information of the back image includes the
image size and URL string which the host can use to request the image.
This sequence is similar to sequence SEQ_2, except the move starts at exit
point.
Invalid conditions:

This sequence move is valid only if there is a check at the exit point. If
there is no check found, error 208 ("Cannot find doc at location for this
sequence move") is returned.

This sequence move is valid only if the request for the image is on the
back side. If the front side image is requested, error 405 ("Scan Side is
Invalid For Selected Sequence Move") is returned.
SEQ_6 If there is check found in the check path, the check moves in the forward
direction and it is pinched at the exit point. This operation will not take place if
there is no check found in the check path. No scanning, printing or MICR
reading operations are performed during this sequence.
Invalid Conditions:

This operation will not take place if there is no check found in the check
path.

A check that is pinched at the exit point (after check processing is
completed) is considered to be out of the path.
SEQ_7 If there is check found in the check path, the check moves in the reverse
direction and it is pinched at the entry point. This operation will not take place if
there is no check found in the check path. No scanning, printing or MICR
reading operations are performed during this sequence.
Invalid Conditions:

This operation will not take place if there is no check found in the check
path.

A check that is pinched at the exit point (after check processing is
completed) is considered to be out of the path.
SEQ_8 If there is check found in the check path, the check moves in the forward
direction towards the exit point, and the check leaves the unit. Motor is always
turned on to ensure the path is completely clear. No scanning, printing or
MICR reading operations are performed during this sequence.
Invalid Conditions:

This operation will not take place if there is no check found in the check
path.

A check that is pinched at the exit point (after check processing is
completed) is considered to be out of the path.