MagTek EC2000 99875692 - Manual (Page 11)

3 - Tipper Heater Replacement Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | Tipper Heater Replacement Procedure
Page 11
Figure 3-7 - Removing / Re-inserting the Tipper Heater (TOP VIEW FROM FRONT)
11) Determine the number of cards the tipper heater has produced, and record the number. Set the tipper
heater aside to return to MagTek for recycling.
To re-install the tipper heater, follow these steps:
1) Orient the tipper heater with the flat side down and the cables coming off to the right (Figure 3-7).
2) Run the cable out the front of the tipper as shown in Figure 3-1 and Figure 3-4.
3) Hold the tipper heater up in place with one hand as shown in Figure 3-6.
4) Insert and hand-tighten the right spring-loaded post, making sure it holds the tipper heater up.
Figure 3-8 - Hand-tightening the First Spring-loaded Post (RIGHT VIEW)