3 - tipper heater replacement procedure – MagTek EC2000 99875692 User Manual
Page 9
Advertising
3 - Tipper Heater Replacement Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | Tipper Heater Replacement Procedure
Page 9
Figure 3-3 - Tipper Heater Plug (FRONT RIGHT VIEW)
7) Use the 3/32” Allen wrench to remove the two screws that secure the tipper sensor to the tipper
housing, and set them aside.
Figure 3-4 - Tipper Sensor Screws (FRONT RIGHT VIEW)
8) Carefully pull the tipper sensor out of the right side of the tipper housing, and move it out of the way
by looping it up and over the top of the tipper module.
Advertising