Dump (d), Version request (v) – MagTek MODEL MT-85 User Manual
Page 18
MT-85 RS-232 Reader/Encoder
12
Dump (D)
The "D" command will dump its internal configuration.
Request:
1 2
3
4 5
<STX> <ESC> D <ETX>
*
*BCC is ignored in this command, even if enabled.
Response:
1 2
3
4
5
6
7
8-63
64
65
<STX>
<ESC>
44H
x
x
x
[Y]
Not used - Reserved
for future use.
<ETX> {BCC}
(opt)
Locations 4-6 indicate which tracks are enabled. Enabled tracks contain the value 44H; disabled
tracks are 00Hex; location 4 is Track 1, location 5 is Track 2, and location 6 is Track 3. The
communication byte [Y] in location 7 is defined in Table 3-1, above.
Version Request (V)
The “V” command requests the firmware part number and version.
Request:
1 2
3
4 5
<STX> <ESC> V <ETX>
*
*BCC is ignored in this command, even if enabled.
Returns the MT-85’s firmware version.
Response:
1
2
3 – 10
11 -13
14
15
<STX> V [Part
Num] [Revision] <ETX> {BCC}
[Part Num] is 8 decimal digits. [Revision] is a single letter (the major revision) followed by two
decimal digits (the minor revision). For Example: <STX>V15033401F01<ETX>{BCC}