MagTek USB INSERTION READER - Manual (Page 13)

5
SECTION 2. INSTALLATION
This section describes the cable connections, the Windows Plug and Play Setup, and the physical
mounting of the unit.
USB CONNECTION
Connect the optional USB cable to a USB port on the host. The reader and optional cable
connectors are shown in Figures 2-1 and 2-2.
Figure 2-1. Cabling for 2-track Models
The 5-pin connections between the Reader and the USB connector shown in Figure 2-1 are listed
in Table 2-1. The connector part number on the PCB is Molex 53048-0510.
Table 2-1. 5-Pin Molex Connector (J1)
Pin Number Signal
1 V
CC
2 - Data
3 +Data
4 Ground
5 Shield Ground