MagTek USB INSERTION READER - Manual (Page 15)

Section 2. Installation
7
WINDOWS PLUG AND PLAY SETUP
On hosts with the Windows operating system, the first time the device is plugged into a specific
USB port, Windows will pop up a dialog box, which will guide you through the process of
installing a device driver for the device. After this process is completed once, Windows will no
longer request this process as long as the device is plugged into the same USB port. The device
driver that Windows will install for this device is the driver used for HID devices and it is part of
the Windows operating system. When the dialog box pops up, follow the instructions given in
the dialog box. Sometimes Windows will find all the files it needs on its own without giving any
prompts. Other times Windows will need to know the location of the files it needs. If Windows
prompts for the file locations, insert the CD that was used to install Windows on your PC and
point Windows to the root directory of the CD. Windows should find all the files it needs there.
MOUNTING
Figure 2-1 shows the board layout and indicates the cable connections.
Note
As shown in Figure 2-1, there is also a cable connector, which may
add to the length of the unit. If used as shown, approximately 1.5”
inch is added to the length of the unit.
For users who are interested in designing their own bezel, refer to the dimensions in Appendix C.
Figure 2-2 shows the dimensions for mounting when using a MagTek Bezel. The top view and
the side view show the heads mounted above and below the PCB with connectors J2 and J3.