MagTek MT-211232 RS-232 1 OR 2 TRACK - Manual (Page 20)

MT-211 RS-232 Swipe Reader, 1 or 2 Tracks
12
POWER ADAPTERS
For standard 110 volt AC operation, the MT-211232 must be powered by the 9 volt DC adapter
supplied with the unit. For 220 volt operation, a 220 volt/AC 9volt DC conversion adapter
(suitable for international use), part number 64300065, must be provided instead of the 9 volt
adapter supplied.
For users who wish to supply their own power supply, requirements are:
Output Voltage 7.5 to 15 VDC, filtered @ 300 mA, regulated or unregulated, to a 3.5 mm Mono
Plug, positive to tip, negative to shank.
SWITCH SETTINGS
There are two blocks of switches; they are labeled A and B. The blocks are located on the
bottom of the Reader. Each switch block contains eight switches. Figure 2-4 shows the
switches and the ON/OFF positions. The switches settings shown in the illustration are not
necessarily the default settings. Ensure power is off before setting the switches to ensure the
switches are properly loaded.
Figure 2-4. Switches