MagTek USB KB INTELLIHEAD - Manual (Page 33)

Section 4. USB Communications
25
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Example Set ASCII To Keypress Conversion Type property Request (Hex):
Cmd Num Data Len Prp ID Prp Value
01 02 0F 00
Example Set ASCII To Keypress Conversion Type property Response (Hex):
Result Code Data Len Data
00 00
Example Get ASCII To Keypress Conversion Type property Request (Hex):
Cmd Num Data Len Prp ID
00 01 0F
Example Get ASCII To Keypress Conversion Type property Response (Hex):
Result Code Data Len Prp Value
00 01 00
INTERFACE TYPE PROPERTY
Property ID:
0x10
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 1 (keyboard emulation)
Description: The value is a byte that represents the devices interface type. The value can
be set to 0 for the HID interface or to 1 for the keyboard emulation interface.
When the value is set to 0 (HID) the device will behave as described in the
HID manual. When the value is set to 1 (keyboard emulation) the device will
behave as described in the keyboard emulation manual. This property should
be the first property changed because it affects which other properties are
available. After this property is changed, the device should be power cycled
before changing any other properties.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.