MagTek USB KB INTELLIHEAD - Manual (Page 41)

Section 4. USB Communications
33
If only Track 2 is available:
<PAN><TAB><TAB><MM><TAB><YY><Termination Character>
If Track 1 and Track 2 are not in financial data format or cannot be decoded,
the reader will revert back to standard mode.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Rules used for determining that a card is in financial data format:
• PAN length should be between 13 and 19
• Name length should be between 0 and 26 characters for Track 1
• Only 2 field separators (‘^’) for Track 1
• Only 1 field separator (‘=’) for Track 2
• Format code shall be the character ‘B’ for Track 1
Example Set PAN Name Date Enable property to 01 Request (Hex):
Cmd Num Data Len Prp ID Prp Value
01 02 1D 01
Example Set PAN Name Date Enable property Response (Hex):
Result Code Data Len Data
00 00
Example Get PAN Name Date Enable property Request (Hex):
Cmd Num Data Len Prp ID
00 01 1D
Example Get PAN Name Date Enable property Response (Hex):
Result Code Data Len Prp Value
00 01 01
*This property was not added until firmware version 21042812L02.