AT&T E2562 - Manual (Page 55)

Light remains on while batteries
are charging.
LOW BATTERY
RDL MEM MENU
Battery & charger installation
After installation, place the handset in the charger and allow the battery to charge for 12
hours before use. You can keep the battery charged by returning the handset to the charger
after each use. When battery power is fully depleted, a full recharge takes about 8 hours.
Press coin into slot on
base of handset to
release latch, then
remove cover
Insert supplied
battery
Place handset in charger for
12 hours before first use
Low battery indicator
Return handset to charger when this
symbol flashes. (Handset will beep
when battery is low.)
Caution: Use only supplied
rechargeable battery.
Insert top
tab first
Press down to
click in place
Plug power cord into jack on under-
side of charger, then plug transformer
into electrical outlet
ATT-252CIB-d1.qxd 12/30/2003 2:00 PM Page 2