Termination char property, Ss tk2 7bits property – MagTek USB KB SURESWIPE & USB KB SWIPE READER User Manual
Page 33
Section 4. USB Communications
25
TERMINATION CHAR PROPERTY
Property ID:
0x05
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x0D (carriage return)
Description:
This property is defined as follows:
mod
c
c
c
c
c
c
c
mod
0 – Send c after card data
1 – Send c after each track
c
1-127 – 7 bit ASCII char code
0 – send nothing
This property is stored in non-volatile memory, so it will persist when the unit is
power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
SS TK2 7BITS PROPERTY
Property ID:
0x06
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x40 ‘@’
Description:
This character is sent as the track 2 start sentinel for cards that have track 2
encoded in 7 bits per character format. If the value is 0 no character is sent. If
the value is in the range 1 – 127 then the equivalent ASCII character will be
sent.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.