Post tk char enable property, Host poll timeout property – MagTek USB KB SURESWIPE & USB KB SWIPE READER User Manual
Page 46
USB Keyboard Emulation Swipe Reader
38
Example Get PAN Name Date Enable property Response (Hex):
Result Code Data Len
Prp Value
00
01
01
Note
* This property was not added until firmware version 21042812L02. This
property only exists in swipe readers, not SureSwipe readers.
POST TK CHAR ENABLE PROPERTY
Property ID:
0x1E
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x07
Description:
This property is used to enable or disable the post track character for each
track individually. The post track character is set separately with the post
track character property. To enable the post track character for a given track
set its corresponding bit position to one. To disable it, set it to zero. The
following table shows how this properties bit positions relate to each track.
Bit
position
7
6
5
4
3
2
1
0
Track
Reserved Reserved Reserved Reserved Reserved
3
2
1
The reserved track fields should always be set to zero. For example, to enable
all three tracks set this property to 0x07. To enable only track 1 set this
property to 0x01.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Note
This property was not added until firmware version 21042812L02.
This property only exists in swipe readers, not SureSwipe readers.
HOST POLL TIMEOUT PROPERTY
Property ID:
0x52
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x02 (2 seconds)
Description:
This property can be used to adjust the device’s host poll timeout. The
property can be set to 0 to disable the timeout or it can be set to a value in the
range of 1 to 60 seconds.