MagTek USB KB SURESWIPE & USB KB SWIPE READER - Manual (Page 48)

USB Keyboard Emulation Swipe Reader
40
RESET DEVICE COMMAND
Command number:
0x02
Description: This command is used to reset the device. This command can be used to
make previously changed properties take affect without having to unplug
and then plug in the device. When the device resets it automatically does
a USB detach followed by an attach. After the host sends this command
to the device it should close the USB port, wait a few seconds for the
operating system to handle the device detach followed by the attach and
then re-open the USB port before trying to communicate further with the
device.
Data structure: No data is sent with this command
Result codes: 0x00 (success)
Example Request (Hex):
Cmd Num Data Len Data
02 00
Example Response (Hex):
Result Code Data Len Data
00 00
GET KEYMAP ITEM COMMAND
Command number:
0x03
Description: This command is used to get a key map item from the active key map. The
active key map is determined by the active key map property. Data from a
magnetic stripe card is a sequence of ASCII characters. These ASCII
characters are mapped to key strokes and these key strokes are sent to the
host to represent the ASCII character. The key map maps a single ASCII
character to a single USB key usage ID and USB key modifier byte. The
key usage ID and the key modifier byte are transmitted to the host via USB
to represent the ASCII character. The ASCII value is the value of the
ASCII character to be transmitted to the host. See an ASCII table for the
values of the ASCII character set. The USB key usage ID is a unique value
assigned to every keyboard key. For a list of all key usage IDs see
Appendix A. The key modifier byte modifies the meaning of the key usage
ID. The modifier byte indicates if any combination of the right or left Ctrl,
Shift, Alt or GUI keys are pressed at the same time as the key usage ID.
For a list and description of the key modifier byte see Appendix B.
Starting with the firmware release with software ID 21042812F01, when
both the key usage ID and the key modifier byte are set to 0xFF for a given
ASCII value, the ALT ASCII code is sent instead of the key map values.
The ALT ASCII code is a key press combination consisting of the decimal
value of the ASCII character combined with the ALT key modifier. For
example, to transmit the ASCII character ‘?’ (063 decimal), keypad ‘0’ is
sent combined with left ALT key modifier, next keypad ‘6’ is sent