Wagner SMART SideKick Roller - Manual (Page 11)

English
© Wagner Spray Tech - All Rights Reserved 11
Cleanup (continued)
5. Remove container from pump. Leave suction tube
submerged into the bucket of the appropriate cleaning
solution.
6. Hang the roller arm from the bucket.
7. Fully press and release the handle button to run the
appropriate cleaning solution through the hoses and
roller arm.
Note: Allow the pump to circulate the cleaning solution
for about 10 minutes. If desired, refill the bucket with new
cleaning solution and repeat for another 5 minutes.
8. While unit is self-cleaning, disassemble the roller
assembly*, and thoroughly clean the roller cover, core,
and cap by hand.
* Insert thumb to first knuckle, pry and pull the cap from
the roller cover. Once the cap is removed, push the core
out the other end. DO NOT throw away the core and
cap.
9. Fully press and release the handle button to switch the
motor off.
Remove suction tube from solution and run motor until
all cleaning solution is purged from the unit. Turn the
switch OFF. Unplug power cord.
10. Press quick-release tabs and remove the roller arm from
the roller handle. Remove any remaining paint with the
appropriate cleaning solution and a damp cloth.
IMPORTANT: If you used mineral spirits to clean your
unit, you must repeat all the steps on this page using
warm, soapy water.
6
9
8
7
5
ON
10
CLEANING
SOLUTION