Wagner SMART SideKick Roller - Manual (Page 6)

English
6 © Wagner Spray Tech. - All Rights Reserved
Setup
Material Preparation:
Make sure the material you plan on using is
thoroughly stirred and free from debris. Strain if
necessary. Any impurities in the material can cause
clogs in the pump system or roller assembly.
Note: The SideKick™ Roller can be used with any
type of one-gallon or five-gallon paint container.
Setup:
1. Pull the suction tube (a) and extension (b) from
their place holders. This will allow the tube guide
to move more easily.
Lift the suction tube guide (c) to provide
clearance for the material container.
2. Position the material container next to the pump
assembly (d) as shown. The container handle
(e) should be vertical and placed in between the
suction tube guide and the extension holder.
Slide the suction tube guide (f) down until it
touches the top of the material container.
Note: The container is now secured to the pump
and the entire unit can be carried by the container
handle.
IMPORTANT: The container handle must be
placed between the suction tube guide and the
extension holder, or the container will tip when
carried due to the added weight of the pump
assembly.
Continued on next page.
Scan this QR code with your
mobile device and you will be
directed to a video on how to set
up your Power Roller.
(b)
(a)
(c)
(d)
(e)
(f)
1
2
(d)
(f)
(e)
One-gallon Five-gallon