Wagner SMART SideKick Roller - Manual (Page 12)

English
12 © Wagner Spray Tech. - All Rights Reserved
Storage / Maintenance
You will need:
• Petroleum jelly
• An old toothbrush or other similar cleaning brush
Cleaning and Storage Tips:
• Wrap the paint hose around the extension
holder and rest the roller arm assembly on the
pump underneath the suction tube for easy
storage.
• Keep water, paint, and other residues away from
the handle button. A clogged handle button
will affect the performance of your unit.
• Be sure that your unit is free from all fluids
before storage. After storing your unit in
extreme cold temperatures, allow unit to reach
room temperature before using.
• When storing your unit, be sure the paint hose
is stored in a large loop without any kinks. If it is
bent, it could be damaged.
IMPORTANT: Store the unit indoors with the
power cord wrapped safely around the pump.
This unit contains no serviceable
electrical parts. Do not attempt to
service the unit yourself.
Maintenance
The areas on the roller handle indicated below must
be cleaned thoroughly and lubricated after each use.
ALL paint should be removed from the areas
highlighted in gray below, especially the quick-
release tabs and all other areas that connect
with other parts. This can be done by using the
appropriate cleaning solution and an old toothbrush.
Quick-release tabs
Connecting area
IMPORTANT: Do not submerge roller handle.
In addition to thoroughly cleaning your unit after
every use, you must clean and lubricate the areas on
the roller arm indicated below. Use a thin layer of
petroleum jelly to lubricate the indicated areas.
Proper lubrication will prolong O-ring and seal life,
and keep your unit functioning smoothly.
O-ring
Connecting
area
Seal
Connecting area
Reassembly
When all of the components have been throughly
cleaned, dried, and lubricated, you can now
reassemble the roller assembly and roller arm for
storage.
1. Reassemble the cap and core into the roller
cover.
2. Reattach the roller assembly (cap, core and
cover) to the roller arm.
3. Press the quick-release tabs on the roller handle
and attach the the roller assembly to the roller
handle.