Wagner Power Painter - Manual (Page 3)

English
© Wagner Spray Tech - All Rights Reserved 3
Important Safety Information
WaRnInG - To reduce the risk of skin
injection:
1. Do not aim the gun at, or spray any person or
animal.
2. Keep hands and other body parts away from the
discharge. For example, do not try to stop leaks
with any part of the body.
3. Always use the nozzle tip guard. Do not spray
without the nozzle tip guard in place.
4. Only use a nozzle tip specified by the
manufacturer.
5. Use caution when cleaning and changing
nozzle tips.
6. High-pressure spray is able to inject toxins into
the body and cause serious bodily injury. In
the event that injection occurs, seek medical
attention immediately.
7. This system is capable of producing 2800
PSI / 193 Bar. Only use replacement parts
or accessories that are specified by the
manufacturer and that are rated a minimum of
2800 PSI. This includes spray tips, nozzle guards
and extensions.
8. Verify that all connections are secure before
operating the unit.
WaRnInG - To reduce the risk of
injury:
1. Always wear appropriate gloves, eye protection,
clothing and a respirator or mask when
painting. Hazardous vapors – Paints, solvents,
insecticides, and other materials can be harmful
if inhaled or come in contact with body. Vapors
can cause severe nausea, fainting or poisoning.
2. Do not operate or spray near children. Keep
children away from equipment at all times.
3. Do not overreach or stand on an unstable
support. Keep effective footing and balance at
all times.
4. Stay alert and watch what you are doing.
5. Do not operate the unit when fatigued or under
the influence of drugs or alcohol.
WaRnInG - To reduce the risk of
electric shock:
1. Keep electrical cord plug and spray gun trigger
free from paint and other liquids. Never hold
cord at plug connections to support cord.
Failure to observe may result in an electrical
shock.
2. Never immerse electrical parts in water or any
other liquid. Wipe the exterior of the sprayer
with a damp cloth for cleaning. Always make
sure the sprayer is unplugged before taking it
apart for cleaning.
Important Electrical
Information
Use only a 3-wire extension cord that has a 3-blade
grounding plug and a 3-slot receptacle that will
accept the plug on the product. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough
to carry the current your product will draw. An
undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. A 14
gauge or 12 gauge cord is recommended. If an
extension cord is to be used outdoors, it must be
marked with the suffix W-A after the cord type
designation. For example, a designation of SJTW-A
would indicate that the cord would be appropriate
for outdoor use.
Wagner Spray Tech accessory extension cords
recommended:
P/N 0090241
20 foot extension cord
P/N 0090242 35 foot extension cord
IMPORTanT: Household use only. Intended for
indoor/outdoor use OnLY with materials having
flashpoint above 70ºF (21ºC).
Capability:
Sprays a variety of materials (oil-based and latex),
stains, preservatives and other nonabrasive materials.
Do not use materials with flash points below 70° F
(21° C).
Do not use!
This pump should not be used with textured
materials, block filler, lacquers, industrial enamels,
or asphalt sealer or materials containing HHC. See
coating supplier if flash point is not listed on the
container.