Wagner Power Painter - Manual (Page 6)

English
6 © Wagner Spray Tech - All Rights Reserved
Setup
You will need:
• Lubricant
note: The cup will give you approximately 3-5 minutes
of continuous spraying time.
IMPORTanT: avoid running the cup dry. an empty
cup will allow air to become sucked into the sprayer,
which leads to globbing and spitting.
Setup:
1. Remove the cup.
2. Fill the container with the material to be used.
3. Place a few drops of lubricant down the intake (a) and
return openings (b) in the pump housing.
4. Insert the suction tube into the intake opening.
note: Make sure the suction tube is inserted as far as it
will go to ensure a tight fit.
5. If you are going to be spraying up, point the suction
tube opening (c) toward the rear of the gun.
If you are going to be spraying down, point the
suction tube opening (d) toward the front of the gun.
6. Thread the container securely to the sprayer. Plug in
the sprayer.
(a) (b)
(c)
(d)
1
2
4 3
6 5