Flytec 6040 * - Manual (Page 11)

Operation Manual FLYTEC 6040 GPS
9
Remark: any screen layout may take a few seconds according to the relevant data volume.
The more Trackpoints are already stored in memory, the more time is required for the completion of
screen layout. If a zoom or pan key is activated during the screen layout, the momentary layout process
will be stopped and will resume with the new values. Thus one can obtain the desired graph rapidly.
The Track is plotted back from the active position. This may be important for the screen layout
during very long flights and short recording intervals.
1.6 „Windlayer“ Display Screen
After a short pressure of the page-key, the windlayer display screen will be displayed just after the
map displiay screen.
Status battery bank 1
Status battery bank 2
1.6.1.1 Shift page of data fields
The seven data fields exist 3 times on each page of data field! Therefore you have the possibility to
configure in total 21 data fields individually!
Short pressing of the right side arrow key gives access to the next page. The page number is shown
in the upper part of the display next to the battery-charge state readout as P1, P2 or P3.
.
See list of the data fields under 1.7. User defiended datafields page 10(depends on the version of
the firmware)
Tipp: This function is also available on the main display screen.
Wind Speed
TT34 Receiption of envelop temp
Status battery of temp receiver
Compass Wind direction mp
Function of F2 key
Function of F1 key
User selectable Datafileds
Analogue Vario
Vario Unitt
Actual altitude / position
number of GPS
satelites
f
Altutde of the
windlayers
Data field page number
Sink audio Alarm
Treshold
Curve indicating
windpower
IInformation lines
km/h
4
20
3
40
2
4
Alt1
GPS
Mod Alt 1 uv
- - -
Alt 1
1013
P1
18
3500
60
1
1
2
3
50
3000
45
2500
31
2000
30
1500
42
1000
15
500
i
Hoehe1 m
QNH hPa
1013
85.2
Huellen Temp
Kurs
16
2018
Gnd Geschw
31
Aktive Information