Flytec 5030 v2.24 * - Manual (Page 32)

Flytec
5030 GPS
previous flight history with up to 30 recording points is logged in the Flytec 5030 GPS's
memory.
Even the last 3 minutes before the start of the logged
flight can be recognized as they are recorded with a
10 second recording interval. An end of flight is
recognized if there is no movement for 60 seconds,
and no change in altitude occurs. Then the Flight
analysis is
displayed. The digital signature is
calculated from this moment on and a notice in the
user defined field draws attention to it. Please wait
until the calculation is completed. You can return to
standard mode by pressing the Menu key briefly. Or
you perform a recalculation of the Digital Signature
by briefly pressing F2.
Main Setup Menu
------------------
Basic Settings
F F l l i i g g h h t t M M e e m m o o r r y y
W W a a y y p p o o i i n n t t s s
Routes
Simulation
Factory Settings
Optional SW-Package
Flight Memory
01.03.02
1:14:56
13.02.02 1:37:34
28.01.02 0:24:05
23.01.02 1:02:24
12.01.02 2:11:45
15.12.01 0:34:55
24.11.01 1:07:32
Del. ii
If however, manual recording was chosen, recording
starts 1 minute after the instrument is switched on
and continues until the Esc key is pressed for 3
seconds. The unit asks you:
“Do really switch off” and you confirm with “ Enter”
Now starts the generation of the digital signature
which can last 1 or 2 minutes. Wait until this is done
and press any key to turn off.
Flight
= = = = = = = = = = = = = = = = =
FLIGHT-ANALYSIS
= = = = = = = = = = = = = = = = =
Start: 13.02.02 13:35:43
Stop: 13.02.02 15:13:22
Flighttime: 1:37:34
Record-Interval: 10 s
Task: no
Max A1: 2823 m
Max A2: 1154 m
Max A3: 4273 m
Max Vario: 8.9 m/s
Min Vario : 6.6 m/s
Max Airspeed: 73 km/h
Bear in mind that modifying of Alt1 cannot be done
after the start of a record. The user field Flight time
starts to count up with the beginning of a record.
Flight Memory is situated in the second position of
the Main Setup Menu. If you press the Enter key, the
list of flights, stored according to date, appears. The
most recent flights are in the first positions. The
length of the flight is also shown. With the
or
key you can move through the list and choose the
desired flight with the Enter key. The flight, with its
benchmark figures, is indicated in the Flight analysis.
Individual flights can be deleted from the list by
pressing F2 Del. Flight.
Note: Before starting a flight make sure that the GPS
receiver shows at least 4 receiving satellites to get a
valid recording.
Show Recal
Map Sign.
Remark 1: In the flight recording the values are
recorded, which appeared on the display. Because the display is renewed each second, thus
the 1 seconds - values are stored in the flight recording. If one downloads such flight
afterwards with a program such as Flychart, SeeYou, CompeGPS, Maxpunkte etc. on the
PC, these programs can analyze only the flight recording in the IGC format. In the IGC file
the position, the barometric height, the GPS height and the True airspeed with impeller
sensor or pitot tube sensor are recorded. The programs calculate now the rate of climb
values by the altitude values. If the pilot chooses for example a recording Interval of 10s, and
in these 10 seconds an altitude difference of 5m occurred, a climb rate of 0.5m/s is
calculated. In this10 seconds it is possible that however a climb rate of of 1m/s occurred.
32/53