Flytec Alti Windwatch User Manual
Page 4
2
Commissioning
Your Alti-Windwatch is always switched on
but enters its energy-saving barometer mode
after approximately 15 minutes if the Wind-
watch is not being used.
The instrument is supplied with a basic con-
figuration. These values can be altered using
the Set and Option modes to suit your own
personal requirements.
Battery compartment
Your Alti-Windwatch is powered by a lithium
battery (3 V, CR 2032). When battery power
is low, the message ‹BAT› appears in the
display.
The instrument is always initialized with the
basic configuration when the battery is re-
placed. The barometer, the time and the alti-
meter all have to be reset.
A watertight membrane in the battery com-
partment serves to equalize pressure. If
your Alti-Windwatch is exposed to too
much humidity (e. g. if dropped into water or
exposed to heavy rain), this membrane must
be carefully dried without delay. Leave the
battery compartment open until the whole
instrument is dry again.
Wind sensor
Display
Menu key
Set-/ Reset mode
Unit key
Option mode
Introduction
Introduction
Commissioning
Battery