Flytec SensBox - Manual (Page 12)

Quick start guide SensBox
12
7.7 Time of day
At this item is displayed the UTC time which is synchronized via
satellite. The adaptation to local time in steps of ½ h is possible in
Setmode.
‹
Time display 7:23:01
7.8 Recording memory
At this item is displayed the storage space of the inserted SD card in
percent. In addition it is possible to adjuste here the recording interval and
the start conditions. The following modes are available, for which
respectively a scanrate of 1 – 2 – 3 – 5 – 10 – 30 sec needs to be adjusted:
Mode O = Manual start and stop by use of the keys, recording termination
and saving on SD card must be confirmed with OK key.
Mode I = Recording begins immediately after switch-on with pre-selected
scanrate.
Mode A = Automatic if the following value changes are present:
10 km/h GPS speed or
1,5 m/s Vario deflection or
30 m change in altitude.
The recording rate is set in Set Mode for each mode.